User`s manual

Loading ELP1 Font
Sets
1. Set the reconfigure the printer for Page
(EPL2) Mode. Send a EPL2 command to the
printer.
2. Send the EPL2 U command to the printer.
The printer will print a Dump Mode status re
-
port. If it prints a U, then the print is still in Line
Mode and steps 1 and 2 need to be repeated.
3. Download the EPL1 Font file
(LMFONT.BIN) with the Firmware
Downloader program. Change the file type pull
down menu to *.BIN files and load the font (and
the embedded command that activate the
EPL1 fonts).
4. Send the EPL2 OEPL1 (Set Line Mode)
command to the printer. Send a Line Mode
EPL? command to the printer to print a Dump
Mode printout. Verify that the printer is in Line
Mode and that the status line immediately be-
low the “Option:” line has, at minimum, the
following: oEw, x, y, z
Cycle the printer power and repeat steps3&4if
the printer is not in Line Mode or the fonts (as
represented by oEw, x, y, z ) are not active and
loaded.
C-2 980353-001 Rev.B