User`s manual

U Command - MaxiCode - 2D Bar Code
Description Use this command to print a MaxiCode bar
code symbol. The printer will automatically in
-
terpret and encode data into MaxiCode sym
-
bols for data modes 2, 3, 4, and 6. Up to eight
symbols can be linked.
Syntax
¬Up
1
,[p
2
,],“DATA”
Parameters p
1
= Horizontal start position from the left
margin in millimeters.
Range = 00 to 99 (millimeters)
Note - The vertical start position is set by line
position.
p
2
= Mode Selection
Value Description
Not Used Automatic Selection Mode 2 or 3
m2 Mode 2
m3 Mode 3
m4 Mode 4
m6 Mode 6
1. If p
2
(mX) is not used, the printer will use the
following rules to automatically format the
DATA parameter. If the postal code (third
parameter, PC) in the “DATA” is:
All numeric characters, the printer will auto
-
matically select Mode 2.
Alpha only or alpha-numeric character com
-
binations will set the printer to Mode 3.
Not used, the printer automatically selects
Mode 3.
3-32
980353-001 Rev.B