User`s manual

D Command - Density
Description Use this command to set print density. This
command controls the amount of heat applied
to the media by the print head.
Syntax
¬Dp
1
Parameters p
1
= Density setting - Line Mode Printing
only!
Model Values
1
Default
2
EPL2
3
2443 / 2844 0-7 5 0-15 10
2722 / 2824 0-7 5 0-15 7
LP Models
(Reference Only)
0-7 5
Note 1: 0 is the lightest print and 7 is the darkest.
Note 2: The printer saves and shares density settings between
Line Mode and Page (EPL2) mode.
Note 3: Range and default density for EPL2 (Page Mode) opera-
tion is listed for reference to the AutoSense Dump Mode printout.
The selected density will remain in effect until
changed or power is removed.
The speed and density commands can dramatically af-
fect print quality. Changes to the speed setting typically
require a change to the print density.
980353-001 Rev.B 3-9