User`s manual

Configuration Zebra EPL flash based printers are, by default,
configured for Page (EPL2) mode operations.
The operator must convert the printer to Line
Mode prior to the initial use of Line Mode. This
is done via a hardware select procedure with the
Feed button during printer power-up.
Line Mode configuration settings are retained after
reset has been issued or power has been cycled.
Manually Setting
Line Mode
The printer utilizes the Feed button during
printer power-up to toggle between printer per
-
sonality modes, Line and Page (EPL2).
1. With printer power off, press and hold the
Feed button while turning the printer on, then
release the button when the LED starts blinking
red.
2. When the indicator LED starts flashing green,
immediately press and hold Feed button.
3. Release the Feed button when the LED turns
a steady Amber (orange).
4. Verify printer personality with Dump Mode
printout:. Line Mode or Page Mode (EPL2).
5. Press the Feed button to exit the Dump
Mode.
Printing on continuous media requires program
-
ming. Use the N command with no parameters to
disable Top of Form (label gap) sensing.
980353-001 Rev.B 1-5