User`s manual

O-24
UMAN-EN3
Wireless Local Area Network (LAN)
Printers equipped for wireless Local Area Network
(LAN) communications are known as Encore 3 N Net-
work Printers. Encore 3N printers allow wireless commu-
nication as a node within a local area network, and its
wireless capabilities allow communications from any
point within the LAN’s perimeter. Methods of establishing
communications to the Encore 3N will vary with each
LAN application.
The printer’s serial number label on the back of the unit
will show the radio module’s identification numbers and/
or its operating frequency.
Encore 3N printers can be identified by a much higher
top cover which contains the radio module and the an-
tenna. The antenna area of an Encore 3N is depicted as
the shaded area on Figure 8 of this section. Please refer
to the safety considerations below and avoid unneces-
sary proximity closer than the mandated 1.5 cm distance
from this area.
Encore 3N Safety Considerations
Caution: In order to comply with FCC RF expo-
sure requirements maintain a 1.5 cm [.6”] spacing
between the front (where the paper exits) of the printer
and all parts of the body excluding wrists, hands,
ankles and feet. Wearing the printer with the shoulder
strap or the belt clip with the back side of the printer
touching the body meets the FCC RF exposure limits as
long as the spacing requirement between the front
side of the printer and the user is satisfied.