User`s manual

O-11
UMAN-EN3
The Encore 3 can be specified to print and separate
labels automatically using a built in label peeler. The
following details media installation when using the label
peeler feature.
Peeler in use (Do not use the label peeler when printing a batch quantity
of labels*)
1. Turn unit off.
2. Press and hold the “Open” button on the front of the
unit. Rotate the top back to reveal the paper compart-
ment
3. Remove the edge guide and any media remaining in
the printer. Install the paper roll on the spindle. Roll
should be against the inside wall of the paper com-
partment.
4. Lead the free end over the rubber roller (platen).
Paper should feed from the top of the paper roll.
5. Lift peeler assembly by depressing “Open” button on
front of unit. Lead edge of stock over the peeler bar
and under the grooved peeler roller. Stock should
emerge from the slot in the front cover.
6. Slide the edge guide back over the spindle and
against the roll of media.
7. Close the top and insure it is securely latched before
beginning to print. Insure labels feed over the peeler
bar. When labels are printed, they will feed out the top
slot in the front of the printer and the liner will feed out
the bottom slot as shown.
Units equipped with optional label presence sensor: If
the sensor is activated, further printing will be inhib-
ited until the most recently printed and separated
label is removed.
INSTALLATION OF MEDIA USING PEELER