User`s manual

O-7
UMAN-EN3
Battery Conditioning
IMPORTANT: Encore 3 batteries must be cycled several
times before maximum capacity is realized.
A battery is cycled by fully charging, then fully
discharging it through normal use.
BATTERIES AND CHARGING
Removing and Replacing Batteries
Refer to Figure 3 below
Batteries are removed from the Encore 3 by the follow-
ing procedure:
1.Face the front of the printer. Push the battery re-
lease button on the right side of the printer towards
the top of the printer.
2.Firmly slide the battery pack out of the printer until it
is clear while still keeping the battery release button
raised.
Batteries are replaced by the following procedure:
1.Align the battery pack to the printer so that the
charger jack faces out.
2.Slide the pack into the printer.
3.The battery will engage with a distinct “click”.
Fig. 3 Encore 3 Battery Installation
Battery Release
Button (lift “up” to
release)
Charger Jack