Service manual

Rev. 1.04
- 9 -
EM 220
Mobile Printer Service Manual
2. Installation and Usage
2-1 Battery Installation
1) Insert the battery on the rear side of the printer,
aligning the battery hook properly.
2) Push the battery into the slot until a snapping
sound is heard.
NOTE
As the battery is not charged at the time of purchase,
charge the battery prior to product use.
(Use the battery charger and/or the optional battery
holder.)
2-2 Battery Charging
2-2-1 Battery Charging Usage
1) Turn off the printer power.
2) Connect the power cord ② to the battery charger ① .
3) Open the Interface Cap ③.
4) Connect the battery charger ① to the power
connector of the printer.
5) Plug the power cord ② into an electrical outlet.
CAUTION
The printer may incur serious damage if the battery
charger provided by Zebra is not used. Zebra is
not legally liable for any such damages. (The voltage
and electrical current specifications of the printer
and battery charger must match.)
WARNING
Turn off the power before charging the battery for
the printer.
①
②
③