Service manual

Rev. 1.04
- 11 -
EM 220
Mobile Printer Service Manual
2-2-3-2 Battery Charging
1) Fasten batteries via the battery
hooks into the Quad Charger as
shown above.
2) Push the battery in until a snapping
sound is emitted.
3) Charging begins as soon as the
battery is completely inserted.
Batteries are charged to 8.4VDC, 0.8A.
4) Push the hook and pull up to extract
the battery.
NOTE
Battery charging status descriptions are as follows.
LED Charging Status Charge Time
Red LED On Charging
Green LED Blinking Over 80% Charged
Green LED On Fully Charged
Red LED Blinking
Error
Replace or Reinstall Battery
2.5 hours
CAUTION
If the red LED is blinking, try removing and then reinserting the battery.
If the red LED continues to blink, please consult the reseller.