User`s manual

I Command - Print Monochrome Graphics
Description This command serves to print a monochrome
graphic panel from a card image previously stored
in the buffer designated for Resin images.
After print completion, the card may be ejected to
the output tray (hopper) or repositioned to print an
-
other image (ribbon panel). Typically the clear var
-
nish, or for some models, the hologram lamination
prints next. Then, a duplex printer may produce ad
-
ditional printing after flipping the card to the oppo
-
site side.
Ribbon panels advance during printing, making the
installed ribbon the overriding factor in choosing
buffers for imaging.
Syntax
I{p1}↵
Parameters p1 = Optional Command Parameter
Print Options
Value Description
None
Prints Monochrome image buffer and Ejects
card.
10
Prints card and returns the card to the print
ready position.
20
For Ribbons with Monochrome (1 panel) and
clear veneer (1 panel) with printer firmware
versions 2.00 and above - Prints card and
returns the card to the print ready position.
Also, if appropriate, synchronizes
multiple-panel ribbon for the next print pass.
For P500s using YMCKOK ribbon, the card
ejects after the last application of either Kr or
laminate, and a prior +DLAMI command
determines whether or not the I 20
command invokes lamination.
For Max3300s using KrO ribbon, informs
printer to synchronize to print Overlay
panels.
30
Print Card but leave in place (Allows
preparation for Module 2 with Module 2
BUSY in P600s.
Max3300 with KrO Ribbon Example:
I 20
IV
MO
MF
I 20
IV
MO
2-48 980081-001 Rev. F
• P3xx M
•
•
•
•
•
P3xx C
P4xx
P500
P600
Max