User`s manual
D/vD Commands - Write Diagonal (Monochrome)
Description Write a monochrome diagonal line graphic by de
-
fining the total height, total width, line thickness
(width) and position in the Monochrome image
buffer. The “D” command writes to the Resin
buffer, and the “vD” command writes to the Var
-
nish buffer. The actual image placed is a rectangle.
Syntax Dp1 p2 p3 p4 p5 p6 p7↵
Parameters p1 = Horizontal (X-axis) start position, in dots.
p2 = Vertical (Y-axis) start position, in dots.
p3 = Horizontal (X-axis) width of graphic, in dots.
p4 = Vertical (Y-axis) height of graphic, in dots.
p5 = Thickness/width of the line, in dots.
p6 = Rotation & Origin:
Value Description Origin
1 90 degrees Lower Left
2 180 degrees Lower Left
p7 = Graphic Mode:
Value Description
0
Reverse Bit-map - Clear print area and load
reverse bit-map image
1
Standard Bit-map - Clear print area and
load bit-map image
2
Merge Bit-map - Overwrite background
bit-map image with printable dot locations
leaving non-printing dot locations alone.
980081-001 Rev. F 2-43
• P3xx M
•
•
•
•
•
P3xx C
P4xx
P500
P600
Max
0
D
O
T
S
LINES
Diagonal Line Image Origin
P3
P4
Figure 2-10
Diagonal Line Values