User`s manual

Z/vZ Commands - Load Bit-map (Monochrome)
Description Loads a monochrome bit-map into a monochrome
image buffer. The printer uses the proceeding “G”
command to specify and control the bit-map place
-
ment.
The Z command places the bit-map in a buffer used
for Resin printing, and the vZ command places the
bit-map in a buffer used for Varnish printing.
Syntax Zdata{CHECKSUM}↵
vZdata{CHECKSUM}↵
Note: NO space
(20 Hex.) exists between the
“Z/vZ” and the “data.”
Parameters data = Uncompressed or compressed Monochrome bit-map
data. The bit-map data must match the size and dimen-
sion specified in the proceeding “G” command.
See Section 1 for the relationship on how monochrome
bit-maps relate to data.
CHECKSUM =
Single byte of XOR data generated
from the image data.
Remember, any chance control characters that ap
-
pear among the data require a preceding open
bracket ([) character. Control characters include Es
-
cape (1B hex), Return (OD hex), and the Open
Bracket (5B hex).
2-38 980081-001 Rev. F
• P3xx M
•
•
•
•
•
P3xx C
P4xx
P500
P600
Max