User`s manual

The encoder will not accept ASCII characters that
are not part of the selected ANSI/ISO data character
set. See C-3 for table of character sets.
The following lists the advanced encoder com
-
mands:
Advanced Encoder Commands
&R
Reset Encoder
2-63
&B
Buffer Track Data
2-65
&L
Read Single Track Data
2-67
&W
Change Encoding Direction
2-68
&D
Change Track Density
2-69
&CDEW
Custom Write Format
2-72
&CDER
Custom Read Format
2-70
The encoder does not write data unless the read
buffer is programmed to read identical data pa-
rameters. Otherwise, an error occurs.
Resetting The
Encoder To ANSI/ISO
Track Defaults
To ensure that the encoder is in the proper configu-
ration, the programmer should reset the encoder to
ANSI/ISO track data, format, density and location.
Reset the encoder to ANSI/ISO defaults with the
following command sequence.
Example: (Escape and Carriage Returns not shown)
&R
&CDEW 0 0
&CDER 0 0
The encoder stores the track settings in flash mem
-
ory. If the encoder is powered down, the printer re
-
tains the last encoder read, write, and track density
settings.
980081-001 Rev. F C-5