User`s manual
+VL Command - Set Lamination Speed
Description This command determines the speed that cards
pass through the Lamination Rollers. An attempt to
enhance performance by increasing speed here in
concert with a higher lamination temperature can
result in heat-distorted cards. Card distortion can
produce encoding errors.
Syntax
#11+VLp1¿
Parameters p1 = Speed
For 1-mil overlaminate ribbon:
p1 = 4500 (default — 4.8mm/s)
For 0.6-mil overlaminate ribbon:
p1 = 2000 (11mm/s)
2-98 980081-001 Rev. F
P3xx M
•
•
P3xx C
P4xx
P500
P600
Max