User`s manual

+DLAMI Command - Set Lamination Configura
-
tion
Description Allows enabling or disabling of Print Station varnish
or Laminator lamination. The associated applica
-
tion occurs with issuance of an IV command, or in
some instances, an I command (In the following Ex
-
amples, look for the +DLAMI that precedes an I or
IV).
Note 1: This command applies to Module-1 and,
therefore, requires no #1 preface.
Note 2: Only one card surface can receive lamina
-
tion material.
Syntax +DLAMIp1p2↵
Parameters p1 = Print Station Varnish
0 = Disable
1 = Enable
p2 = Laminator Station Application
0 = Disable
1 = Enable
2 = Enable and flip to laminate (applies to YMCKO
and YMCK ribbons to laminate the color side after
imaging Kr on the monochrome side)
Examples Using
YMCKO Ribbon
Print YMCK on both sides then laminate first side:
+DLAMI 0 1 Laminate enabled ( side-1 default)
IS 0 Print Y (side 1)
IS 1 Print M (side 1)
IS 2 Print C (side 1)
I Print K (side 1)
IV 10 No varnish, just a return
MF Flip Card & return
+DLAMI 0 0 Disable both varnish & lamination
IS 0 Print Y (side 2)
IS 1 Print M (side 2)
IS 2 Print C (side 2)
I Print K (side 2)
IV Flip card, laminate, eject (no varnish)
980081-001 Rev. F 2-93
P3xx M
•
P3xx C
P4xx
P500
P600
Max