User`s manual
SF Command - Synchronize Film (Overlaminate)
Description Positions Overlaminate Lamination Ribbon with
black index mark at sensor. This is a first-time rib
-
bon synchronization used to position a die-cut
panel a known offset from the Laminator Station of
P500 card printers. The command is only required
for an initialization just after installing an Overlami
-
nate ribbon. Subsequent applications of die-cut
Overlaminate panels occur via offsets from the pre
-
vious panel application.
Note: A Laminator previously set for the application
of Varnish (see TF Command) does not respond to
this command.
Syntax #1SF↵
Parameters None
2-90 980081-001 Rev. F
P3xx M
•
P3xx C
P4xx
P500
P600
Max