User`s manual

+X Command - Change Command Initiator

The card printer responds to commands (with data

or error codes) via the bi-directional serial interface

only. The card printer cannot respond to this com

mand, (other than flagging an error), through the

printer’s parallel interface. The card printer can op

erate with both interfaces attached and communi

cating with the printer.

Description This command adds an alternate command initia

tion character. Some host systems cannot transmit

an Escape command character. The printer then re-

sponds to both the Escape character and the added

command initiation character.

Syntax +Xp1↵

Parameters p1 = A single ASCII character

Where:

33~255=Decimal

21~FF = Hexadecimal

Note: To remove an alternate command initiation

character, send +X with p

< 20Hex (except for

0DHex). A NACK response results, with error code

10 (Syntax Error). Then, Escape remains as the

only command initiation character.

2-86 980081-001 Rev. F

• P3xx M

•

P3xx C

P4xx

P500

P600

Max