User`s manual

&CDEW Command - Write Custom Track Data
The card printer responds to commands (with data
or error codes) via the bi-directional serial interface
only. The card printer cannot respond to this com
-
mand, (other than flagging an error), through a par
-
allel interface. The card printer can operate with
both interfaces attached and communicating with
the printer.
Description Configure the write data to encode a single, selected
track of data.
The &CDEW command in conjunction with the
&CDER command resets the encoder to the default
ISO track density and data format settings.
Note: To send this command directly to a Max En-
coder, use an #21 Initiation instead of just an
Escape.
Syntax
&CDEWp1p2
↵
←ISO Data
&CDEWp1p2

p3
↵
←Raw Data
Parameters
p1 = Track Select: (values 1, 2, 3 or 0 (zero))
Where:
0 resets ALL tracks to ISO default configuration parame-
ters.
p2 = Data Format Select, as follows:
Value
Description - ISO Format Data
0
Reset ALL tracks to ISO default configuration
parameters.
Default Format Select
A
ISO Track 1 Data Format to Track 1
B
ISO Track 2 Data Format to Track 2
C
ISO Track 3 Data Format to Track 3
Custom ISO Track Format Select
aX
Track 1 with ISO Track “X” Format
bX
Track 2 with ISO Track “X” Format
cX
Track 3 with ISO Track “X” Format
X = ISO default track format applied to the selected track
(e.g., A=a1, B=b2, and C=c3.
2-72 980081-001 Rev. F
• P3xx M
•
•
•
•
•
P3xx C
P4xx
P500
P600
Max