User`s manual
&D Command - Change Track Density
The card printer responds to commands (with data
or error codes) via the bi-directional serial interface
only. Printers with parallel interfaces cannot
re
-
spond to this command, (other than flagging an er
-
ror). The card printer can operate with both
interfaces attached and communicating with the
printer.
Description Change an individual track data encoding and de
-
coding density.
Note: To send this command directly to the
Max3000 Encoder, use an #21 Initiation in
-
stead of an Escape.
Syntax &Dp1p2↵
Parameters p1 = Track Select, as follows:
Value
Description
1
Track 1 and 3
2
Track 2
3
Track 3
p2 = Density Select, as follows:
Value
Description
75
75 bpi
210
210 bpi
980081-001 Rev. F 2-69
• P3xx M
•
•
•
•
•
P3xx C
P4xx
P500
P600
Max