Quick Start Guide
Table Of Contents
- Unpacking
- Device Features
- Setting Up the Device
- Installing or Replacing the SIM Card
- Device Charging
- Charging the Device
- Accessories
- 1-Slot Charge Only Cradle
- 1-Slot USB/Ethernet Cradle
- 4-Slot Charge Only Cradle
- 4-Slot Charge Only Locking Cradle
- 1-Slot Workstation Cradle
- USB-C Communication and Charge Cable
- Scanning with Internal Imager
- Ergonomic Considerations
EC50/EC55 Enterprise Computer Quick Start Guide
22
USB-C Communication and Charge Cable
Scanning with Internal Imager
To read a barcode, a scan-enabled app is required. The device contains the DataWedge app that allows
the user to enable the imager, decode the barcode data, and display the barcode content.
To scan with the internal imager:
1. Ensure that an app is open on the device and a text field is in focus (text cursor in text field).
2. Point the exit window on the top of the device at a barcode.
3. Press and hold the scan button.
The red laser aiming pattern turns on to assist in aiming.
NOTE: When the device is in Picklist mode, the imager does not decode the barcode until the crosshair or
aiming dot touches the barcode.
4. Ensure the barcode is within the area formed by the crosshairs in the aiming pattern. The aiming dot
increases visibility in bright lighting conditions.
REVIEW ONLY 8/7/20