Declaration of Conformity

2
Mobile Devices
Co-located Statement
To comply with FCC RF exposure compliance requirement, the antenna used for this transmitter must not
be co-located (within 20 cm) or operating in conjunction with any other transmitter/antenna except those
already approved in this filling.
Hotspot ISED Notice
When operating in hotspot mode, this device is restricted to indoor use when operating in the
5150 - 5350 MHz frequency range.
En mode de connexion partagée (hotspot), l'utilisation de cet appareil doit se faire exclusivement en
extérieur lorsqu'il fonctionne dans la plage de fréquences 5 150 - 5350MHz.
Use with Hearing Aids - FCC
When some wireless devices are used near some hearing devices (hearing aids and cochlear implants),
users may detect a buzzing, humming, or whining noise. Some hearing devices are more immune than
others to this interference noise, and wireless devices also vary in the amount of interference they
generate. In the event of interference, you may want to consult your hearing aid supplier to discuss
solutions.
The wireless telephone industry has developed ratings for some of their mobile phones to assist hearing
device users in finding phones that may be compatible with their hearing devices. Not all phones have
been rated. Zebra terminals that are rated have the rating included on the Declaration of Conformity (DoC)
at www.zebra.com/doc.
The ratings are not guarantees. Results will vary depending on the user’s hearing device and hearing loss.
If your hearing device happens to be vulnerable to interference, you may not be able to use a rated phone
successfully. Trying out the phone with your hearing device is the best way to evaluate it for your personal
needs.
ANSI C63.19 Rating System
In accordance with FCC hearing aid compatibility rules, certain phones be tested and rated under the
American National Standard Institute (ANSI) C63.19 hearing-aid compatibility standard. This standard
contains two types of ratings:
•M-Rating: For reduced radio-frequency interference to enable acoustic coupling with hearing aids that
don’t operate in telecoil mode
•T-rating : For inductive coupling with hearing aids operating in telecoil mode (t-switch or telephone
switch)
These ratings are on a scale from one to four, where four is the most compatible. A phone is considered
hearing-aid compatible under the FCC requirements if it's rated M3 or M4 for acoustic coupling and T3 or
T4 for inductive coupling.
Hearing devices may also be measured for immunity to this type of interference. Your hearing device
manufacturer or hearing health professional may help you find results for your hearing device. The more
immune your hearing aid is, the less likely you are to experience interference noise from mobile phones.
REVIEW ONLY 10/22/20