User manual

A - 2 DS4800 Series Corded Digital Imager Product Reference Guide
Direct I/O Beep N/A Ignore 3-13
Beep Directive N/A Ignore 3-14
Bar Code Configuration Directive N/A Ignore 3-14
IBM Specification Version N/A Original Specification 3-15
User Preferences
Set Default Parameter N/A Set Defaults 4-5
Report Version N/A N/A 4-6
Parameter Bar Code Scanning 236 Enable 4-6
Beep After Good Decode 56 Enable 4-7
Direct Decode Indicator 859 Disable 4-8
Speaker Volume 140 High 4-9
Scan Tone 145 Wood Block / Scan Tone 1 4-10
Suppress Power Up Beeps 721 Do Not Suppress 4-12
LED on Good Decode 744 Enable 4-12
Haptic Feedback (Vibrate) on Good Decode 613 Disable 4-13
Haptic Feedback (Vibrate) on Good Decode
Duration
626 100 msec 4-14
Haptic Feedback (Vibrate) on Trigger Touch 1251 Enable 4-16
Tone on Trigger Touch 1252 Disable 4-16
Hand-Held Trigger Mode 138 Auto Aim 4-17
Hand-Held Decode Aiming Pattern 306 Enable 4-18
Hands-Free (Presentation) Decode Aiming
Pattern
590 Enable Hands-Free
(Presentation) Decode Aiming
Pattern on PDF
4-19
Picklist Mode 402 Disabled Always 4-20
Continuous Bar Code Read 649 Disable 4-21
Unique Bar Code Reporting 723 Enable 4-21
Decode Session Timeout 136 9.9 Sec 4-22
Timeout Between Decodes, Same Symbol 137 0.5 Sec 4-22
Timeout Between Decodes, Different Symbols 144 0.1 sec 4-23
Fuzzy 1D Processing 514 Enable 4-23
Table A-1 Standard Default Parameters Table (Continued)
Parameter
Parameter
Number
Default
Page
Number
1
User selection is required to configure this interface and this is the most common selection.