User manual

12 - 4 DS4800 Series Corded Digital Imager Product Reference Guide
Imager emits low/high beeps
during programming.
Input error or Cancel bar code was
scanned.
Scan the correct numeric bar codes
within range for the parameter
programmed.
Imager emits low/high/low/high
beeps during programming.
Out of ADF parameter storage
space.
Erase all rules and re-program with
shorter rules.
Imager emits a power-up beep
after changing USB host type.
The USB bus re-established power
to the imager.
Normal when changing USB host
type.
Table 12-1 Troubleshooting (Continued)
Problem Possible Causes Possible Solutions
NOTE If after performing these checks the imager still experiences problems, contact the distributor or call
support. See page xviii for the telephone numbers.