User manual

Data Capture 2 - 5
Hands-Free Presentation Scanning
When placed in the presentation intellistand, the imager automatically enters hands-free presentation mode.
Initially in this mode:
• Illumination is off.
• The white trigger LED is off.
• The green indicator LED continuously pulses.
Present a bar code to the imager or swipe the bar code past the exit window:
• Illumination turns on.
• Optionally, the aiming dot turns on if enabled via Hands-Free Decode Aiming Pattern on page 4-19.
• The green indicator LED turns off.
Figure 2-3 Hands-Free Presentation Scanning
When a bar code is decoded:
• A tone sounds (by default). To change the tone, see Scan Tone on page 4-10.
To disable the tone, see Beep After Good Decode on page 4-7.
• The green indicator LED turns on momentarily (by default), then returns to idle state and pulses. To
disable this, see LED on Good Decode on page 4-12.
• Haptic feedback does not occur, even if enabled in hand-held mode.