User manual

4 - 20 DS4800 Series Corded Digital Imager Product Reference Guide
Picklist Mode
Parameter # 402
Picklist mode enables the imager to decode only bar codes that are aligned under the LED aiming dot. Select
one of the following picklist modes for the imager:
• Disabled Always - Picklist mode is always disabled.
• Enabled in Hand-Held Mode - Picklist mode is enabled in hand-held mode.
NOTE To ensure the aiming dot appears during scanning, disable Tone on Trigger Touch on page 4-16 if using
this feature.
*Disabled Always
(0)
Enabled in Hand-Held Mode
(1)
NOTE Picklist Mode temporarily overrides the Disable Decode Aiming Pattern parameters. You can not disable
the decode aiming pattern when Picklist Mode is set to Enable.