User manual

2 - 6 DS4800 Series Corded Digital Imager Product Reference Guide
Hand-Held Presentation Scanning
This mode is disabled by default. Initially in this mode:
• The aiming dot and illumination are off.
• The white trigger LED is off.
• The green indicator LED continuously pulses.
When lifted off the counter or removed from the presentation intellistand:
• The DS4800 detects motion and turns illumination on.
• Optionally, the aiming dot turns on if enabled via Hands-Free Decode Aiming Pattern on page 4-19.
• The green indicator LED turns off.
Aim the imager at a bar code to activate decode processing.
Figure 2-4 Hand-Held Presentation Scanning
When a bar code is decoded:
• A tone sounds (by default). To change the tone, see Scan Tone on page 4-10.
To disable the tone, see Beep After Good Decode on page 4-7.
• The green indicator LED turns on momentarily (by default), then returns to idle state and pulses. To
disable this, see LED on Good Decode on page 4-12.
• If enabled, the imager provides haptic feedback. See Haptic Feedback (Vibrate) on Good Decode on
page 4-13.