User manual

Getting Started 1 - 3
Host Connection
The DS4800 imager supports USB connection to a host. To connect the imager:
1. Plug the USB connector at the end of the cable into a USB port on the host.
Figure 1-2 USB Host Connection
2. The imager defaults to the HID keyboard interface type. To select another USB interface type, scan a
USB Device Type on page 3-3.
3. On first installation when using Windows, the software prompts to select or install the Human Interface
Device driver. To install this driver, provided by Windows, click Next through all the choices and click
Finished on the last choice. The imager powers up during this installation.
If problems occur with the system, see Troubleshooting on page 12-3.
NOTE For a list of supported scanner functionality by USB protocol, see Appendix I, Communication Protocol
Functionality.