Instructions

Intelligent Document Capture 14 - 7
IDC X Coordinate
Parameter Name: DocCap_X
Parameter # 596 (SSI # F4h F1h 54h)
Specify the horizontal offset to the top left corner of the region to capture relative to the center of the barcode.
Negative values move toward the left. This parameter only applies when IDC Operating Mode is set to Anchored.
Scan the barcode below, followed by four barcodes from Appendix H, Numeric Bar Codes in the range of
+/- 1279. The default is -151. Note that you must use an application to set a negative value.
IDC Y Coordinate
Parameter Name: DocCap_Y
Parameter # 597 (SSI # F4h F1h 55h)
Specify the vertical offset to the top left corner of the region to capture relative to the center of the barcode.
Negative values move toward the top. This parameter only applies when IDC Operating Mode is set to Anchored.
Scan the barcode below, followed by four barcode from Appendix H, Numeric Bar Codes in the range of
+/- 1023. The default is -050. Note that you must use an application to set a negative value.
NOTE IDC pertains to the DS36X8-HP configuration only.
IDC X Coordinate
NOTE IDC pertains to the DS36X8-HP configuration only.
IDC Y Coordinate