Instructions

14 - 4 DS36X8 Digital Scanner Product Reference Guide
Parameters
This section describes the parameters controlling the IDC firmware and provides programming barcodes for setting
them.
To set parameters requiring a range of values, scan the parameter barcode followed by two, three, or four
barcodes from Appendix H, Numeric Bar Codes corresponding to the desired value. Scan two numeric barcodes
for parameters with a maximum value of less than 100, for example, IDC Minimum Text Length. IDC Delay Time
requires scanning three digits since the maximum value is 200. Leading zeros are required.
Alternatively, use the sample application to set parameters using the parameter name. The application provides
prompts and error checking to assist in setting the parameters correctly and easily. You must use an application to
set a parameter to a negative value, as the IDC X Coordinate can require.
NOTE IDC pertains to the DS36X8-HP configuration only.
Table 14-1 Intelligent Document Capture (IDC) Parameter Defaults
Parameter Parameter Name
Parameter
Number
SSI Number Default
Page
Number
Intelligent Document Capture (IDC)
IDC Operating Mode
DocCap_MODE 594 F1h 52h Off 14-5
IDC Symbology DocCap_SYMBOLOGY 655 F1h 8Fh 001 14-6
IDC X Coordinate DocCap_X 596 F4h F1h 54h -151 14-7
IDC Y Coordinate DocCap_Y 597 F4h F1h 55h -050 14-7
IDC Width DocCap_WIDTH 598 F1h 56h 0300 14-8
IDC Height DocCap_HEIGHT 599 F1h 57h 0050 14-8
IDC Aspect DocCap_ASPECT 595 F1h 53h 000 14-9
IDC File Format Selector DocCap_FMT 601 F1h 59h JPEG 14-10
IDC Bits Per Pixel DocCap_BPP 602 F1h 5Ah 8 BPP 14-11
IDC JPEG Quality DocCap_JPEG_Qual 603 F1h 5Bh 065 14-12
IDC Find Box Outline Sig_FINDBOX 727 F1h D7h Disable 14-12
IDC Minimum Text Length DocCap_MIN_TEXT 656 F1h 90h 00 14-13
IDC Maximum Text Length DocCap_MAX_TEXT 657 F1h 91h 00 14-14
IDC Captured Image
Brighten
Sig_BRIGHTEN 654 F1h 8Eh Enable 14-15
IDC Captured Image
Sharpen
Sig_SHARPEN 658 F1h 92h Enable 14-16
IDC Border Type DocCap_BORDER 829 F2h 3Dh None 14-17
IDC Delay Time DocCap_DELAY 830 F2h 3Eh 000 14-18
IDC Zoom Limit Sig_MIN_PERCENT 651 F1h 8Bh 000 14-18
IDC Maximum Rotation Sig_MAX_ROT 652 F1h 8Ch 00 14-19