Instructions

7 - 2 DS36X8 Digital Scanner Product Reference Guide
Scanning Sequence Examples
In most cases scanning one barcode sets the parameter value. For example, to disable image capture illumination,
scan the Disable Image Capture Illumination barcode under Image Capture Illumination on page 7-5. The digital
scanner issues a fast warble beep and the LED turns green, signifying a successful parameter entry.
Other parameters require scanning several barcodes. See these parameter descriptions for this procedure.
Errors While Scanning
Unless otherwise specified, to correct an error during a scanning sequence, just re-scan the correct parameter.
Imaging Preferences Parameter Defaults
Table 7-1 lists the defaults for imaging preferences parameters. To change the default values, scan the appropriate
barcodes in this guide. These new values replace the standard default values in memory. To recall the default
parameter values, scan * Restore Defaults on page 6-5.
NOTE See Appendix A, Standard Default Parameters for all user preferences, hosts, symbologies, and default
parameters.
Table 7-1 Imaging Preferences Parameter Defaults
Parameter
Parameter
Number
SSI Number Default
Page
Number
Imaging Preferences
Operational Modes N/A N/A N/A 7-4
Image Capture Illumination 361 F0h 69h Enable 7-5
Image Capture Autoexposure 360 F0h 68h Enable 7-5
Fixed Exposure 567 F4h F1h 37h 100 7-6
Gain / Exposure Priority for Snapshot
Mode
562 F1h 32h Autodetect 7-7
Snapshot Mode Timeout 323 F0h 43h 0 (30 Seconds) 7-8
Snapshot Aiming Pattern 300 F0h 2Ch Enable 7-9
Silence Operational Mode Changes 1293 F8h 05h 0Dh Disable (do not silence) 7-9
Image Cropping 301 F0h 2Dh Disable 7-10
Crop to Pixel Addresses 315
316
317
318
F4h F0h 3Bh
F4h F0h 3Ch
F4h F0h 3Dh
F4h F0h 3Eh
0 top
0 left
959 bottom
1279 right
7-11
Image Size (Number of Pixels) 302 F0h 2Eh Full 7-13