Instructions

Radio Communications 5 - 37
Pairing Methods
Parameter # 545
(F1h 21h)
There are two methods available to pair (connect) the digital scanner to the cradle:
• Scan the pairing barcode on the cradle
or
• Pair on contacts by inserting the scanner into the cradle.
When the Bluetooth connection beeps sound, the scanner and cradle connect. See Wireless Beeper Definitions on
page 5-4 for other beep sequences.
Enable or disable Pair on Contacts by scanning the appropriate barcode below.
Pull Trigger Twice to Re-connect
Upon a double trigger press, the digital scanner attempts to connect to the last known address. This feature differs
from auto-reconnect (see Reconnect Attempt Beep Feedback on page 5-25) in that the digital scanner attempts
connection only once and keeps the address even on commanded disconnect. The last known address is only
cleared upon a reject or with a new successful connection. The address persists over scanner reboot.
NOTE When Pair on Contacts is enabled you may still scan the pairing barcode on the cradle. You can enable
or disable Pair on Contacts for the cradle type by scanning the appropriate barcode below.
* Enable Pair On Contacts
(1)
Disable Pair on Contacts
(0)
IMPORTANT This feature only applies to hosts capable of a commanded connection; SPP slave and HID BLE
hosts do not support this feature.
NOTE This feature does not interfere with a double trigger press to open/close an iOS keypad in HID mode.