User manual

Getting Started 1 - 11
Prefix Add prefix to decode data
Note: This field must contain a printable
keystroke ASCII hex code as defined in
Table G-1 on page G-1 .
To program non-printable and non-ASCII
characters shown in the Appendix G, ASCII
Character Sets
tables, use parameter bar
code programming in Data Options on page
3-33 .
Byte <none>
ScanLED Enable of disable the LEDs that illuminate
while the laser scanner is active
1 = Enabled
0 = Disabled
Enabled
ScanParam Any scanner parameter. Multiple entries are
allowed. Sent after reset or whenever
scanner is powered.
For example:
ScanParam=0xf0,0x00,0x01
ScanParam=0xee,0x01
ScanParam=0x38,0x00
Variable N/A
Separator Separator character Byte ',’
Sleep Time in seconds before device enters sleep
mode if no activity is detected
Word 14400 (4 hours)
Suffix Add suffix to decode data
Note: This field must contain a printable
keystroke ASCII hex code as defined in
Table G-1 on page G-1 .
To program non-printable and non-ASCII
characters shown in the Appendix G, ASCII
Character Sets
tables, use parameter bar
code programming in Data Options on page
3-33
.
Byte <none>
TimeFormat Time format for data stored in batch 1 = 12h
0 = 24h
24h
WakeUpBeep Enable or disable wake up beep 1 = Enabled
0 = Disabled
Disabled
WakeUpLED Enable or disable wake up LEDs 1 = Enabled
0 = Disabled
Disabled
ZeroOutHIDClassOfDevice Some versions of Broadcom stack
experience issues when connecting to HID
devices. Enable this feature if this is the
case.
1 = Enabled
0 = Disabled
Disabled
Table 1-1 Config.ini File Content (Continued)
Name Description Values Default