User manual

Standard Default Parameters A - 5
Set Length(s) for Code 39 18, 19 1 to 55 5-33
Code 39 Check Digit Verification 48 Disable 5-34
Transmit Code 39 Check Digit 43 Disable 5-34
Code 39 Full ASCII Conversion 17 Disable 5-35
Code 39 Security Level 750 Security Level 1 5-36
Code 93
Code 93 9 Enable 5-37
Set Length(s) for Code 93 26, 27 1 to 55 5-37
Code 11
Code 11 10 Disable 5-39
Set Lengths for Code 11 28, 29 4 to 55 5-39
Code 11 Check Digit Verification 52 Disable 5-41
Transmit Code 11 Check Digit(s) 47 Disable 5-42
Interleaved 2 of 5 (ITF)
Interleaved 2 of 5 (ITF) 6 Enable 5-43
Set Lengths for I 2 of 5 22, 23 6 to 55 5-43
I 2 of 5 Check Digit Verification 49 Disable 5-45
Transmit I 2 of 5 Check Digit 44 Disable 5-46
Convert I 2 of 5 to EAN 13 82 Disable 5-46
I 2 of 5 Security Level 1121 Security Level 1 5-47
Discrete 2 of 5 (DTF)
Discrete 2 of 5 5 Disable 5-48
Set Length(s) for D 2 of 5 20, 21 1 to 55 5-48
Codabar (NW - 7)
Codabar 7 Enable 5-50
Set Lengths for Codabar 24, 25 4 to 55 5-50
CLSI Editing 54 Disable 5-52
NOTIS Editing 55 Disable 5-52
Codabar Upper or Lower Case Start/Stop
Characters Detection
855 Upper Case 5-53
Table A-1 Default Table (Continued)
Parameter
Parameter Number
(Hex)
Factory Default
Page
Number