Instructions

Symbologies 4 - 13
User-Programmable Supplementals
Supplemental 1: Parameter # 0xF1 0x43
Supplemental 2: Parameter # 0xF1 0x44
If you selected a Supplemental User-Programmable option from Decode UPC/EAN Supplementals on page
4-9, select User-Programmable Supplemental 1 to set the 3-digit prefix. Then select the 3 digits using the
Numeric Bar Codes on page 4-49. Select User-Programmable Supplemental 2 to set a second 3-digit prefix.
Then select the 3 digits using the Numeric Bar Codes on page 4-49.
User-Programmable Supplemental 1
User-Programmable Supplemental 2
Decode UPC/EAN Supplemental Redundancy
Parameter # 0x50
With Autodiscriminate UPC/EAN Supplementals selected, this option adjusts the number of times a symbol
without supplementals are decoded before transmission. The range is from 2 to 30 times. Five or above is
recommended when decoding a mix of UPC/EAN symbols with and without supplementals, and the
autodiscriminate option is selected.
Scan the bar code below to select a decode redundancy value. Next scan two bar codes from Numeric Bar
Codes on page 4-49. Single digit numbers must have a leading zero. To change the selection or cancel an
incorrect entry, scan Cancel on page 4-51.
Decode UPC/EAN
Supplemental Redundancy
(Default: 7)