Instructions

Getting Started 1 - 3
Charging the Scanner Battery
To charge the CS3000 series scanner, connect it to a host PC via the USB host cable or charging cradle. No
power supply is necessary. Charge time is approximately three hours for a fully discharged battery.
Charging via USB Host Cable
1. Insert the mini-USB connector on the host cable in the interface port on the scanner.
2. Connect the other end of the host cable to a USB port on the host PC.
Figure 1-4 Connecting Scanner to Host PC
The scanner begins charging. A complete charge of a fully discharged battery takes approximately three
hours. Charge within the recommended temperature of 32° to 104° F (0° to 40° C).
NOTE To check the battery charge status, hold the scan (+) button for 15 seconds. See Battery charge status in
Table 2-1 on page 2-3.
NOTE An authorized Zebra repair facility can replace the CS3000 battery. Changing the battery does not affect
bar code data which is stored in non-volatile memory, however the date and time is lost upon changing the
battery or if the battery completely loses charge.