Reference Guide

Radio Communications
52
device. See the <bl_blue><em_Emphasis>Pairing Barcode Format Using the Scan-To-Connect (STC)
Utility on page 9-74 for information about creating a pairing barcode.
Master
When the digital scanner is set up as a Master (SPP), it initiates the radio connection to a slave device.
Initiating the connection is done by scanning a pairing barcode for the remote device (see
<bl_blue><em_Emphasis>Pairing Barcode Format Using the Scan-To-Connect (STC) Utility on page
9-74).
Slave
When the digital scanner is set up as a Slave device (SPP), the digital scanner accepts an incoming
connection request from a remote device.
Bluetooth Friendly Name
Parameter # 607 (SSI # F1h 5Fh)
You can set a meaningful name for the digital scanner that appears in the application during device
discovery. The default name is the digital scanner name followed by its serial number, e.g., CS6080
123456789ABCDEF. Scanning Set Defaults reverts the digital scanner to this name; use custom defaults
to maintain the user-programmed name through a Set Defaults operation.
To set a new Bluetooth Friendly Name, scan the following barcode, then scan up to 23 characters from
<em_Emphasis><bl_blue>Appendix H, Alphanumeric Barodes. If the name contains less than 23
characters, Then scan End of Message in the Advanced Data Formatting Guide.
note The number of digital scanners is dependent on the host capability.
note If your application allows you to set a device name, this takes precedence over the Bluetooth Friendly
Name.
Bluetooth Friendly Name
guide-user-color-8.5x11.book Page 52 Monday, June 1, 2020 5:43 PM
Draft v 10