Reference Guide

41
Radio Communications
Introduction
This chapter provides information about the modes of operation and features available for wireless
communication between the CS6080 cordless digital scanners, cradles and hosts. The chapter also
includes the parameters necessary to configure the digital scanner.
The digital scanner ships with the settings shown in the <bl_blue><em_Emphasis>Radio Communication
Default Table on page 9-42 (also see <em_Emphasis><bl_blue>Appendix A, Standard Parameter Defaults
for all defaults). If the default values suit requirements, programming is not necessary.
Setting Parameters
To set feature values, scan a single barcode or a short barcode sequence. The settings are stored in
non-volatile memory and are preserved even when the scanner powers down.
If not using the default host, select the host type (see each host chapter for specific host information) after
the power-up beeps sound. This is only necessary upon the first power-up when connected to a new host.
To return all features to default values, scan a barcode in <bl_blue><em_Emphasis>Default Parameters
on page 6-5. Throughout the programming barcode menus, asterisks (
*) indicate default values.
Scanning Sequence Examples
In most cases, scanning one barcode sets the parameter value. For example, to enable Wi-Fi Friendly
Mode, scan the Enable Wi-Fi Friendly Mode barcode listed under <bl_blue><em_Emphasis>Wi-Fi
Friendly Mode on page 9-54. The scanner issues a fast warble beep and the LED turns green, signifying a
successful parameter entry.
note Most computer monitors allow scanning barcodes directly on the screen. When scanning from the screen,
be sure to set the document magnification to a level where you can see the barcode clearly, and bars
and/or spaces do not merge.
*Enable Parameter
(1)
Feature/option
* Indicates default
Option value
guide-user-color-8.5x11.book Page 41 Monday, June 1, 2020 5:43 PM
Draft v 10