Reference Guide

User Preferences
122
Hands-free Decode Session Timeout
Parameter # 400 (SSI # F0h 90h)
This parameter is the hands-free compliment to the Decode Session Timeout. It configures the minimum
and maximum decode processing time during a hands-free scan attempt. It only applies to the hands-free
trigger mode or when a scanner is placed in the Presentation cradle (CR6080-PC).
The minimum decode processing time is defined as the time in which the scanner stops decoding when an
object is removed or left stationary in the imaging field of view.
The maximum decode processing time is defined as the time in which the scanner stops decoding when
an object is left in and is moving in the field of view.
Both the maximum and minimum times are configured using a single setting. The relationship of this
setting is as follows:
For example, a setting value of 100 results in the scanner turning off approximately 1 second after an
object is removed from the field of view or 10 seconds while an object is in the field of view moving.
The default value of the setting is 15 which results in a Minimum time of 250 ms and Maximum time of 1.5
seconds.
Adjust this setting based on your requirements. For example, when doing PDF prioritization, this parameter
should be set to a value where the maximum time is above the PDF prioritization timeout.
Setting Value Minimum Time Maximum Time
X < 25 250 ms X * 100 ms
X >= 25 X * 10 ms X * 100 ms
Hands-free Decode Session Timeout
guide-user-color-8.5x11.book Page 122 Monday, June 1, 2020 5:43 PM
Draft v 10