Specifications

Mobile Printing Systems CPCL Programming Manual
Section 10
Advanced
Utilities
pg. 10-15
continued
LT Command
This command specifies the command line terminator character(s). The default terminator characters
are CR/LF or LF. The printer can be programmed to accept a different character sequence to terminate
command lines. This command does not apply to data sent to the printer when it is in line print mode.
Format:
{command} {mode}
Where:
{command}: LT
{mode}: Choose from the following.
CR: Carriage-return (0x0D) character is the line terminator.
LF : Line-feed (0x0A) character is the line terminator.
CR-LF: Carriage-return/line-feed (0x0D 0x0A) characters are the line terminator.
CR-X-LF: Line terminator is a carriage-return (0x0D) followed by any number of characters followed
by the line-feed (0x0A) character. Characters found between the carriage-return and line-feed
characters are discarded.
LT Command Examples:
Set the printer to require line-feeds only as a terminating character.
! UTILITIES LT LF PRINT
Set the printer to ignore any characters found between a carriage return character and a line-feed
character.
! UTILITIES LT CR-X-LF PRINT