User's Manual

pg. 8 of 12 AM16629-1 Rev. C
PRINTER INSTALLATION
Printer Preparation
Prepare the printer for installation by doing the following:
• If your printer has a carrying strap, you must remove it by the following procedure
(Refer to Figure 4) :
1. Unscrew the (2) #4-40 x 1” screws holding the top corners of the printer together.
2. Remove the Carrying Strap and the (2) Bushings.
3. Replace the Bushings back in the top corners of the printer and re-install the two
#4-40 x 1” screws
• Remove the Belt Clip from the back of the Printer (Refer to Figure 4).
• If your printer is equipped with a shoulder strap, remove it by un-clipping each end
from the “D” rings.
• Always install the Battery prior to mounting the printer in the Mobile Mount.
Remove Belt Clip by
removing (2) screws.
Remove Carrying Strap by un-
screwing corner screws
Replace bushings and screws after
removing carrying strap.
Remove Carrying strap.
Figure 4:
Printer Preparation