User Manual

RMAN-Cameo rev. C • 2- 42 •
Removing the Magnetic Card Reader (MCR)
This procedure is valid if PCC digit 12 = 1 or 3.
1. Remove the media and battery. Refer to the Cameo User’s Manual .
2. Remove the Top Cover. Refer to “Top Cover - Cameo 2 & 3.”
3. Loosen the CPU Board by removing the 4 screws.
4. Unplug the MCR from the CPU Board.
5. Remove the 3 screws from the MCR.
Installing the Magnetic Card Reader (MCR)
This procedure is valid if PCC digit 12 = 1 or 3.
1. Secure the MCR with (3) #2-56 x 7/16” Socket Head Screws, (3) #2 Flat Washers
Nylon and (3) Shock Mounts.
Note: Screws will bottom out into inserts, thus allowing card reader to
float freely.
2. Dress the MCR Cable so that it is not pinched or strained.
3. Secure the CPU Board by installing the 4 M3 x 10 mm Self-Tapping Screws. Refer
to “CPU Board - Cameo 2.”
4. Install the Top Cover. Refer to “Top Cover - Cameo 2 & 3.”
5. Install the Media and Battery. Refer to the Cameo User’s Manual .
MAGNETIC CARD READER, CAMEO 2 - BC15257-1
You must use an ESD strap and work at a properly grounded
workstation (antistatic mat or tray). All electronic components must
be placed on an ESD protective tray. If stored, any electronic
components must be placed in antistatic bags.
Magnetic Card Reader
Shock Mount (3)
#2-56 x 7/16” Socket Head Screw (3)
#2 Flat Washer Nylon (3)
Dress the cable