User Manual

• 2- 33 • RMAN-Cameo rev. C
MOTOR, CAMEO 2 AND 3- AN16793-008
You must use an ESD strap and work at a properly grounded
workstation (antistatic mat or tray). All electronic components must
be placed on an ESD protective tray. If stored, any electronic
components must be placed in antistatic bags.
Be careful not to damage the actuator on the head open switch
while working on the Cameo Chassis.
Removing the Motor
1. Remove the media and battery. Refer to the Cameo User’s Manual .
2. Remove the Top Cover. Refer to “Top Cover - Cameo 2 & 3.”
3. Loosen the CPU Board (4 screws in Cameo 2 or 2 screws and a clip in Cameo 3).
Refer to either “CPU Board - Cameo 2” or “CPU Board - Cameo 3.”
4. Loosen the Printer Assembly (3 screws in Cameo 2 or 2 screws in Cameo 3). Refer
to either “Printer Assembly - Cameo 2” or “Printer Assembly - Cameo 3.”
5. Remove the 2 screws from the motor.
6. Pull the motor out and unplug it from the CPU Board.
Installing the Motor
1. If you are installing a new motor in an old printer, replace the Print Head Mount with
the new Mount supplied with the new Motor.
2. Install the Motor.
2a. Install the motor as shown, positioning the motor so that the spline meshes with
the gear, and install the 2 4-40 x 1/4 Self-Tapping Screws.
2b. Dress the Eye Sensor Cable over the top of the motor.
2c. Plug the Motor Cable into the CPU Board (J3 in Cameo 2 or J11 in Cameo 3).
3. Install the Printer Assembly Refer to either “Printer Assembly - Cameo 2” or “Printer
Assembly - Cameo 3.”
4. Secure the CPU Board. Refer to either “CPU Board - Cameo 2” or “CPU Board -
Cameo 3.”
5. Install the Top Cover. Refer to “Top Cover - Cameo 2 & 3.”
6. Install the Media and Battery. Refer to the Cameo User’s Manual .
#4-40 x 5/16” Self-Tapping Screw
Note orientation of cable.
Motor
#4-40 x 5/16” Self-Tapping Screw