User Manual

• 2- 23 • RMAN-Cameo rev. C
Tools:
• #1 Phillips Head Screwdriver.
• #1 Slot Head Screwdriver.
• Spring insertion tool p/n AU16259-1 (optional)
• ESD strap and mat
Removing the Print Head Assembly
1. Remove the Media.
Turn the printer off, remove the battery, open the Media Cover, and remove any
media. Refer to the Cameo Portable Printers User’s Manual .
2. Remove the Top Cover.
Remove the 2 Phillipps screws from the back of the printer and remove the 2
Phillipps screws from the front of the printer. Refer to “Top Cover - Cameo 2 and 3.”
3. Loosen the CPU board.
Loosen the CPU Board (4 Phillipps screws in Cameo 2, retaining clips in Cameo 3)
as described in either “CPU Board - Cameo 2” or “CPU Board - Cameo 3.”
4. Unplug the Print Head Cable and the Ground Strap from the CPU board. Refer to
either “CPU Board - Cameo 2” or “CPU Board - Cameo 3.”
5. Remove the Print Head Assembly from the Print Mechanism. On each side of the
print head, carefully pry the Print Head Latch and carefully pry the Print Head
Assembly out of the Print Mechanism.
PRINT HEAD ASSEMBLY, CAMEO 2- CC14036-1 & CAMEO 3- CC15301-1
You must use an ESD strap and work at a properly grounded
workstation (antistatic mat or tray). All electronic components must
be placed on an ESD protective tray. If stored, any electronic
components must be placed in antistatic bags.
Be careful not to damage the actuator on the head open switch
while working on the Cameo Chassis.