User Manual

RMAN-Cameo rev. C • 2- 14 •
916 MHZ ANTENNA, CAMEO 2 - AN16730-031
Installing the 916 MHz Antenna (PCC digit 7 = 3)
Insert the Antenna into the very bottom edge of the Chassis as shown below.
Dress the antenna lead between the mounting bosses on the Lower Chassis so
that the wire is not pinched when the top cover is installed. Secure the antenna
to the lower chassis with Super-Bond tape.
Complete the installation as described in “CPU - Cameo 2.”
You must use an ESD strap and work at a properly grounded
workstation (antistatic mat or tray). All electronic components must
be placed on an ESD protective tray. If stored, any electronic
components must be placed in antistatic bags.
Be careful not to damage the actuator on the head open switch
while working on the Cameo Chassis.
Antenna Assembly 916 MHz
Cameo 2 Chassis
Dress Antenna lead
between mounting bosses.