User Manual

• 2- 13 • RMAN-Cameo rev. C
SRRF MODULES, CAMEO 2, 916 MHZ,- AN16793-026; 2.4 GHZ- AN16824-013-
& BLUETOOTH- AN16793-032
You must use an ESD strap and work at a properly grounded
workstation (antistatic mat or tray). All electronic components must
be placed on an ESD protective tray. If stored, any electronic
components must be placed in antistatic bags.
Be careful not to damage the actuator on the head open switch
while working on the Cameo Chassis.
Installing the SRRF module (PCC digit 7 = 3, 4, or B)
NOTE: If you are installing a Bluetooth radio module for use in Japn, you must attach the
Bluetooth Japan Regulatory label (p/n AA17023-1) over the existing FCC ID label on the
radio module prior to installation.
1. Plug the Antenna into the SRRF module.
Plug the Antenna into the antenna socket in the SRRF module. The antenna socket
is on the side of the SRRF module that does not have any connectors.
2. Plug the SRRF module into the bottom of the CPU Board. The 8-pin connector on
the SRRF module plugs into the connector on the bottom of the CPU Board marked
RF1.
3. Install the Antenna board in the chassis. Refer to the appropriate antenna section
that follows on the next 2 pages.
Insert the Antenna into the very bottom edge of the Chassis. Dress the antenna
lead between the mounting bosses on the
Lower Chassis so that the wire is not
pinched when the top cover is installed.
Secure the antenna to the lower chassis
with Super-Bond tape.
4. Complete the installation as
described in “CPU Board - Cameo 2.”
SRRF Module