User Manual

RMAN-Cameo rev. C • 2- 12 •
6. Install the Top Cover. Refer to “Top Cover - Cameo 2 & 3.”
7. Install the Battery and Media. Refer to the Cameo Portable Printers User’s Manual .
Install the CPU Board
Warning: When installing the CPU, make sure that all cables are
properly routed and not being stretched or crimped.
3. Dress the Antenna attached to the SRRF Assembly and secure with Super-Bond
tape.
4. Carefully move all wires away from the two slots in raised area directly behind the
printer. Attach the CPU board to the printer chassis with (4) M3 x 10 mm Self-
Tapping Screws.
Note: The SRRF Board must be retained by the two bosses on the Lower Case.
Note: Insure that the battery contacts on the bottom of the CPU board fit through the two slots
in raised area directly behind the printer without pinching any cables, and that no
cables are pinched between the PC Assembly and its mounting posts.
5. Set the Symbol Compatibility Switch
Using a small slotted-head screwdriver, turn SW4 on the CPU Board:
If PCC digit 10 = 0, set SW4 to the “Comtec” setting by turning the switch counter-
clockwise until it stops.
If PCC digit 10 = 1, set SW4 to the “Other” setting by turning the switch clockwise
until it stops.
Turn SW4 counter clockwise
towards “Comtec” if PCC digit
10 = 0; clockwise towards
“Other” if PCC digit 10 = 1.
COMTEC
OTHER
COMTEC
OTHER