User Manual

• 2- 11 • RMAN-Cameo rev. C
2. Connect the Cables to the CPU Board
Warning: The Tear Bar on the Printer Assembly has sharp edges. Use
caution when working near the printer.
Plug cables into the CPU board as follows:
From # of pins to CPU Connector #
Head-Open Switch 2 J1
MCR (PCC digit 12 = 1 or 3) 8 J2
Printer Motor 4 J3
Printer Eye Sensor 3 J5
Printhead Ground Flex circuit J6
Printhead 28 Circuits Flex J7
7 J10
SRRF (PCC digit 7 = 2, 8 or B) 8 RF1
Cameo 2 CPU
MCR cable to J2 on CPU
M3 x 10 mm Self Tapping Screw (4)
SRRF Assy.
Motor cable to J3 on CPU
Printhead shield cable to J6 on CPU
Printhead cable to J7 on CPU
Eye Sensor to J5 on CPU
Head Up Switch cable to J1 on CPU
Dress Antenna from SRRF
Assembly , and secure
with Super Bond Tape.
Antenna location for 433 MHz 1
way