User Manual

RMAN-Cameo rev. C • 2- 6 •
MEDIA COVER, CAMEO 2 - AN16793-005 & CAMEO 3- AN16794-003
Tools
• #1 Slot Head Screwdriver.
Removing the Media Cover
1. Open the Media Cover and remove media.
2. Remove the Media Cover.
Carefully press the Hinge Pin from right to left through the media cover hinge until
the media cover is free.
Installing the Media Cover
1. Install the Cover.
Line up the Media Cover hinges with the Lower Cover hinges and press the Hinge
Pin through the covers in the direction shown (from the side with the gear). Press the
pin until it stops.
2. Insert media and close the cover.
You must use an ESD strap and work at a properly grounded
workstation (antistatic mat or tray). All electronic components must
be placed on an ESD protective tray. If stored, any electronic
components must be placed in antistatic bags.
Media Cover
Hinge Pin