User Manual

RMAN-Cameo rev. C • 2- 4 •
TROUBLESHOOTING
Never use any sharp objects on the printer mechanism as it could
damage the print head. Use only isopropyl alcohol, the supplied
cleaning pen and /or a cotton swab for cleaning the printer.
Self Test:
Perform the self test as described in the Controls section. The unit should print
a line of interlocking “x” characters to insure all elements of the print head are
working, print out the version of software loaded in the printer and then print
two reports. The first report indicates model, ROM version, serial number,
baud rate, etc. The second report contains application information. If no
second report appears, there is no application loaded.
Cameo 3N units will also print out a “RF LAN Information” section with
information regarding the printer’s status on your facility’s’s wireless Local Area
Network (WLAN).
Troubleshooting Guide
No power
• Check battery, recharge or replace as necessary.
Media does not feed:
• Be sure media compartment cover is closed and latched.
Poor or faded print:
• Clean print head.
• Check/replace battery.
• Check quality of media.
Partial/missing print:
• Check media alignment
• Clean print head.
•Verify media compartment cover is closed and latched
Prints illegible characters:
• Check baud rate.
No print:
• Check baud rate
• Replace battery
• Check cable connection to terminal
•Wireless units: verify communication link between printer and terminal
Continued on Next Page