User Manual

ManualsBrandsZebra Manualsprinter/scanner spare partsAN16793-003

Proprietary Statement

This manual contains proprietary information of Zebra Technologies

Corporation and its subsidiaries (Zebra Technologies). It is intended solely for

the information and use of parties operating and maintaining the equipment

described herein. Such propriety information may not be used, reproduced, or

disclosed to any other parties for any other purpose without the expressed

written permission of Zebra Technologies.

Product Improvements

Continuous improvement of products is a policy of Zebra Technologies. All

specifications and designs are subject to change without notice.

FCC Compliance Statement

Digital apparatus has been tested and found to comply with the limits for a

Class B Digital Device, pursuant to Part 15 of the FCC Rules. These limits are

designed to provide reasonable protection against harmful interference when

the equipment is operated in a commercial environment. This equipment

generates, uses, and can radiate radio frequency energy and, if not installed

and used in accordance with the product manuals, may cause harmful

interference to radio communications. Operation of this equipment in a

residential area is likely to cause harmful interference in which case the user

will be required to correct the interference at his own expense.

The user is cautioned that any changes or modifications not expressly

approved by Zebra Technologies could void the userÕs authority to operate

the equipment. This unit was tested with shielded cables on the peripheral

devices. Shielded cables must be used with the unit to insure compliance.

WARNING: EXPOSURE TO RADIO FREQUENCY RADIATION ON SOME

MODELS. TO CONFORM TO FCC RF EXPOSURE REQUIREMENTS THIS

DEVICE SHALL BE USED IN ACCORDANCE WITH THE OPERATING

CONDITIONS AND INSTRUCTIONS LISTED IN THIS UNITÕS USERÕS

MANUAL.

Canadian DOC Compliance Statement

Digital apparatus does not exceed the Class A limits for radio noise emissions

from digital apparatus as set out in the radio interference regulations of the

Canadian Department of Communications.

Liability Disclaimer

Zebra Technologies takes steps to assure that its published Engineering

specifications and manuals are correct; however, errors do occur. Zebra

Technologies reserves the right to correct any such errors and disclaims

liability resulting therefrom.

Limitation of Liability

In no event shall Zebra Technologies or anyone else involved in the creation,

production or delivery of the accompanying product (including hardware and

software) be liable for any damages whatsoever (including, without limitation,

consequential damages including loss of business profits, business

interruption or loss of business information) arising out of the use of or the

results of use of or inability to use such product, even if Zebra Technologies

has been advised of the possibility of such damages. Some jurisdictions do not

allow the exclusion or limitation of incidental or consequential damages, so the

above limitation or exclusion may not apply to you.

Copyrights

The copyrights in this manual and the label printer described therein are

owned by Zebra Technologies. All rights are reserved. Unauthorized

reproduction of this manual or the software in the label printer may result in

imprisonment of up to one year and fines of up to $10,000 (17 U.S.C.506).